Mosfet Gate Titan V3 Expert Module

You can use this Gate Titan V3 Expert Module MOSFET to lift your airsoft replica’s performance to the next level. It has several functions that grant complete control over the performance of your airsoft replica, so you can easily adapt to each situation. The MOSFET is very easy to install and you can quickly adjust the various settings.

Proximity trigger sensor
This sensor allows you to finely tune the trigger sensitivity. The MOSFET features no less than 300 different trigger sensitivity levels, so you can adjust the trigger however you like.

Fire selector
This function enables you to set different firing modes to the fire selector positions. You can choose between the following firing modes: safe, semi, binary, burst, burst/auto, auto & semi ramping.

Pre-cocking
You can use the pre-cocking function to pre-cock the spring. This greatly improves your reaction time when pulling the trigger, allowing you to shoot slightly faster. This means you can be somewhat more efficient while airsofting.

Smart trigger
The MOSFET features a smart trigger function, which contributes to a fast reaction time. That’s because it shoots the first shot with an ROF of 100%. Following shots are then shot with the pre-set ROF.

Sniper delay
The Gate Titan V3 Expert module MOSFET uses this function to allow you to meet the demands that certain airsoft fields put on their DMR players. You can set the pause after pulling the trigger from 0.2 seconds to a maximum of 3 seconds for the Advanced firmware and you can set it from 0.01 seconds to a maximum of 5 seconds for the Expert firmware.

Low battery warning
With this function, you won’t have to check the battery level yourself. Instead, the airsoft replica will tell you when the battery is almost running out. The motor will start vibrating at a pre-set battery level. It does so at regular intervals, so you can easily recognise the signal